STD-ASTM CXXXX Conti 3
ASTM A , ASTM B , ASTM C | 1 || 2 || 3 |, ASTM D , ASTM E , ASTM F , ASTM G ,
- ASTM C948 : EN-Standard Test Method for Dry and Wet Bulk Density Water Absorption and Apparent Porosity of Thin Sections of Glass-Fiber Reinforced Concrete
- ASTM C949 : EN-Standard Test Method for Porosity in Vitreous Whitewares by Dye Penetration
- ASTM C950 : EN-Standard Practice for Repair of a Rigid Cellular Polyurethane Insulation System on Outdoor Service Vessels
- ASTM C950/C950M : EN-Standard Practice for Repair of a Rigid Cellular Polyurethane Insulation System on Outdoor Service Vessels
- ASTM C951 : EN-STANDARD SPECIFICATION FOR UREA-FORMALDEHYDE- BASEDFOAMED-IN-PLACE INSULATION
- ASTM C952 : EN-Standard Test Method for Bond Strength of Mortar to Masonry Units
- ASTM C953 : EN-STANDARD TEST METHOD FOR TIME OF SETTING OF GROUTS FOR PREPLACED- AGGREGATE CONCRETE IN THE LABORATORY
- ASTM C954 : EN-STANDARD SPECIFICATION FOR STEEL DRILL SCREWS FOR THE APPLICATION OF GYPSUM BOARD OR METAL PLASTER BASES TO STEEL STUDS FROM 0.033 IN. (0.84 MM) TO 0.112 IN. (2.84 MM) IN THICKNESS
- ASTM C954 REV A : EN-Standard Specification for Steel Drill Screws for the Application of Gypsum Panel Products or Metal Plaster Bases to Steel Studs From 0.033 in. (0.84 mm) 에 0.112 in. (2.84 mm) 두께에
- ASTM C955 : EN-Standard Specification for Load-Bearing (Transverse and Axial) Steel Studs Runners (Tracks) and Bracing or Bridging for Screw Application of Gypsum Panel Products and Metal Plaster Bases
- ASTM C955 REV A : EN-Standard Specification for Load-Bearing (Transverse and Axial) Steel Studs Runners (Tracks) and Bracing or Bridging for Screw Application of Gypsum Panel Products and Metal Plaster Bases
- ASTM C955 REV B : EN-STANDARD SPECIFICATION FOR LOAD-BEARING (TRANSVERSE AND AXIAL) STEEL STUDS RUNNERS (TRACKS) AND BRACING OR BRIDGING FOR SCREW APPLICATION OF GYPSUM BOARD AND METAL PLASTER BASES
- ASTM C956 : EN-Standard Specification for Installation of Cast-in-Place Reinforced Gypsum Concrete
- ASTM C957 : EN-STANDARD SPECIFICATION FOR HIGH-SOLIDS CONTENT COLD LIQUID- APPLIED ELASTOMERIC WATERPROOFING MEMBRANE WITH INTEGRAL WEARING SURFACE
- ASTM C957 REV A : EN-Standard Specification for High-Solids Content Cold Liquid-Applied Elastomeric Waterproofing Membrane With Integral Wearing Surface
- ASTM C957/C957M : EN-Standard Specification for High-Solids Content Cold Liquid-Applied Elastomeric Waterproofing Membrane With Integral Wearing Surface
- ASTM C958 : EN-Standard Test Method for Particle Size Distribution of Alumina or Quartz by X-Ray Monitoring of Gravity Sedimentation
- ASTM C959 : EN-STANDARD SPECIFICATION FOR RADIANT HEAT FILL
- ASTM C960 : EN-STANDARD SPECIFICATION FOR PREDECORATED GYPSUM BOARD
- ASTM C960/C960M : EN-Standard Specification for Predecorated Gypsum Board
- ASTM C961 : EN-Standard Test Method for Lap Shear Strength of Hot-Applied Sealants
- ASTM C962 : EN-Standard Guide for Use of Elastomeric Joint Sealants
- ASTM C963 : EN-Standard Specification for Packaging Identification Shipment and Storage of Lock-Strip Gaskets
- ASTM C964 : EN-Standard Guide for Lock-Strip Gasket Glazing
- ASTM C965 : EN-Standard Practice for Measuring Viscosity of Glass Above the Softening Point
- ASTM C966 : EN-Standard Guide for Installing Asbestos-Cement Nonpressure Pipe
- ASTM C967 : EN-Standard Specification for Uranium Ore Concentrate
- ASTM C967 REV A : EN-Standard Specification for Uranium Ore Concentrate
- ASTM C968 : EN-Standard Test Methods for Analysis of Sintered Gadolinium Oxide-Uranium Dioxide Pellets
- ASTM C969 : EN-Standard Practice for Infiltration and Exfiltration Acceptance Testing of Installed Precast Concrete Pipe Sewer Lines
- ASTM C969M : EN-Standard Practice for Infiltration and Exfiltration Acceptance Testing of Installed Precast Concrete Pipe Sewer Lines (미터)
- ASTM C97 : EN-Standard Test Methods for Absorption and Bulk Specific Gravity of Dimension Stone
- ASTM C97/C97M : EN-Standard Test Methods for Absorption and Bulk Specific Gravity of Dimension Stone
- ASTM C970 : EN-Standard Practice for Sampling Special Nuclear Materials in Multi-Container Lots
- ASTM C971 : EN-Standard Guide for Selection and Application of Insulation Systems for Heating Ventilating and Air Conditioning Duct Work
- ASTM C972 : EN-Standard Test Method for Compression-Recovery of Tape Sealant
- ASTM C973 : EN-Standard Practice for Preparing Test Specimens From Basic Refractory Gunning Products by Pressing
- ASTM C974 : 주조에 의해 기본 내화물 캐스터 블 제품로부터 시험편을 제조하는 EN-STANDARD 연습
- ASTM C975 : EN-표준 연습 눌러 기본 내화물 래밍 제품에서 시험편을 준비하기위한
- ASTM C976 : 보정 핫 박스에 의해 건물 어셈블리의 열 성능에 대한 EN-표준 시험 방법
- ASTM C977 : 토양 안정화를위한 생석회와 수화 된 라임에 대한 EN-표준 사양
- ASTM C977 REV : 토양 안정화를위한 생석회 및 소석회를위한 EN-표준 사양
- ASTM C978 : 편광 현미경과 광학 지연 보상 절차를 사용하여 투명 유리 매트릭스에서 잔류 응력의 광탄성 결정을위한 EN-표준 시험 방법
- ASTM C979 : 일체형으로 컬러 콘크리트 용 안료에 대한 EN-표준 사양
- ASTM C980 : 벽돌 라이닝 산업 굴뚝을위한 EN-표준 사양
- ASTM C981 : 건물의 데크 용 빌드 업 아스팔트 막 방수 시스템의 설계를위한 EN-표준 가이드
- ASTM C982 : GENERIC 에너지 분산 X 선 형광위한 구성 요소를 선택하기위한 EN-표준 가이드 (XRF) 핵에 대한 시스템- 관련 자료 분석
- ASTM C983 : 화학 및 액체 금속 고속 증식로 IN 금속 코어 구성 요소의 기기 분석을위한 EN-표준 방법 (LMFBR)
- ASTM C984 : PERLITE BOARD 단단한 CELLULAR 폴리 우레탄 복합 지붕 단열을위한 EN-표준 사양
- ASTM C985 : NONREINFORCED 콘크리트 명시된 강도 CULVERT 폭풍의 배수 및 하수 파이프 EN-표준 사양
- ASTM C985 REV B : NONREINFORCED 콘크리트 명시된 강도 CULVERT 폭풍의 배수 및 하수 파이프 EN-표준 사양 (E1-1987)
- ASTM C985M : NONREINFORCED 콘크리트 명시된 강도 CULVERT 폭풍의 배수 및 하수 파이프 EN-표준 사양 (METRIC)
- ASTM C985M REV B : NONREINFORCED 콘크리트 명시된 강도 CULVERT 폭풍의 배수 및 하수 파이프 EN-표준 사양 (E1-1987)
- ASTM C986 : 핵연료주기에 대한 교육 프로그램을 개발을위한 EN-표준 가이드
- ASTM C987 : EN-Standard Practice for Vapor Attack on Refractories for Furnace Superstructures
- ASTM C987 REV A : EN-Standard Practice for Vapor Attack on Refractories for Furnace Superstructures
- ASTM C988 : EN-STANDARD TEST METHOD FOR ADHERENCE OF PORCELAIN ENAMEL COVER COATS DIRECT-TO-STEEL
- ASTM C989 : EN-Standard Specification for Ground Granulated Blast-Furnace Slag for Use in Concrete and Mortars
- ASTM C989 REV A : EN-Standard Specification for Ground Granulated Blast-Furnace Slag for Use in Concrete and Mortars
- ASTM C989 REV B : EN-Standard Specification for Ground Granulated Blast-Furnace Slag for Use in Concrete and Mortars
- ASTM C99 : EN-Standard Test Method for Modulus of Rupture of Dimension Stone
- ASTM C99/C99M : EN-Standard Test Method for Modulus of Rupture of Dimension Stone
- ASTM C990 : EN-Standard Specification for Joints for Concrete Pipe Manholes and Precast Box Sections Using Preformed Flexible Joint Sealants
- ASTM C990 REV A : EN-Standard Specification for Joints for Concrete Pipe Manholes and Precast Box Sections Using Preformed Flexible Joint Sealants
- ASTM C990M : EN-Standard Specification for Joints for Concrete Pipe Manholes and Precast Box Sections Using Preformed Flexible Joint Sealants (미터)
- ASTM C990M REV A : EN-Standard Specification for Joints for Concrete Pipe Manholes and Precast Box Sections Using Preformed Flexible Joint Sealants [미터]
- ASTM C991 : EN-STANDARD SPECIFICATION FOR FLEXIBLE GLASS FIBER INSULATION FOR PRE- ENGINEERED METAL BUILDINGS
- ASTM C992 : EN-Standard Specification for Boron-Based Neutron Absorbing Material Systems for Use in Nuclear Spent Fuel Storage Racks
- ASTM C993 : EN-STANDARD GUIDE FOR IN-PLANT PERFORMANCE EVALUATION OF AUTOMATIC PEDESTRIAN SNM MONITORS
- ASTM C994 : EN-STANDARD PRACTICE FOR CERAMOGRAPHIC PREPARATION OF PUO2-UO2 MIXED OXIDE FUEL PELLETS AND URANIUM PELLETS
- ASTM C995 : EN-STANDARD TEST METHOD FOR TIME OF FLOW OF FIBER- REINFORCED CONCRETE THROUGH INVERTED SLUMP CONE
- ASTM C996 : EN-Standard Specification for Uranium Hexafluoride Enriched to Less Than 5% 235U
- ASTM C997 : EN-Standard Test Methods for Chemical and Instrumental Analysis of Nuclear-Grade Sodium and Cover Gas
- ASTM C998 : EN-Standard Practice for Sampling Surface Soil for Radionuclides
- ASTM C999 : EN-STANDARD METHOD FOR SOIL SAMPLE PREPARATION FOR THE DETERMINATION OF RADIONUCLIDES
ASTM A , ASTM B , ASTM C | 1 || 2 || 3 |, ASTM D , ASTM E , ASTM F , ASTM G ,
